NU-CALGON 4287-08 - Nickel-Safe Ice Machine Cleaner
Nickel-Safe Ice Machine Cleaner is a specially formulated citric/phosphoric food-grade product for removing scale deposits from ice makers having nickel-plated or tin-plated evaporators. It is acceptable for use in machines made by Manitowoc and other manufacturers using nickel. In fact, it was the industry’s first nickel-safe product, introduced in collaboration with Manitowoc. Usage rate should be in accordance with the manufacturers instructions or 16 fluid ounces with three gallons of system water.
The number one category of problems troubling an ice machine are water-related, and the most frequently is lime scale. As the water is frozen into ice during an ice maker’s cycle, the naturally occurring dissolved minerals in the water . . . some of which can combine to form lime scale . . . remain behind in the unfrozen recirculating ice water simply because water tries to freeze in its pure state. As the cycle continues and more water is made into ice, the minerals over concentrate and eventually precipitate as a lime scale deposit.
As the scale begins to form, it creates a physical obstruction that results in: plugged distribution holes, restricted water flow and eventually the ice maker will hang-up or jam. Ice harvest is reduced and eventually the machine will shut down, requiring service.
This sequence of events can affect both cubes and flakers. Some believe that flakers are free of scale problems since all of the water is made into ice. Not true. Flakers can scale-up as well, jamming the auger and eventually resulting in a broken belt or drive mechanism.
Once the machine is scaled up, it must be cleaned, requiring the use of an acid so that the scale can be dissolved. Obviously, the acid must be effective in order to dissolve the scale but it must also be food grade and equipment-safe.
1. Turn off refrigeration, shut off water supply and remove ice from bin.
2. Remove water trough, water curtain(s), water distribution tube(s), and other parts that may be scaled with deposits.
3. Mix 3 oz. Nickel-Safe Ice Machine Cleaner per gallon of warm water in plastic container and place components in solution. Soak the components until they are free of deposits; for stubborn or thick deposits use a soft brush to help the dissolving action.
4. Use above solution to clean storage bin, top, bottom and side extrusions and other components where deposits have collected, then rinse cleaned areas with fresh water.
5. Replace cleaned components and turn on water.
6. To clean evaporator as well as the remaining recirculating water system, add Nickel-Safe to the water in ice maker according to the manufacturer’s instructions. If none are available, use 5 fl. oz. of Nickel-Safe per gallon of water in the machine.
7. Allow cleaning solution to circulate for up to 10 minutes; it may be necessary to recirculate the solution for longer than 10 minutes to remove heavier and thicker scale deposits. Be sure all distribution and weep holes are clear. Drain cleaning solution and flush with fresh water for a minimum of 30 seconds. After flushing, plug the drain.
8. Thoroughly rinse bin with clean water after all components are cleaned.
This product must be used in accordance to the following directions by HVACR professionals only
Nu-Calgon #4287-08 Specifications
Restrictions and Compliance
Read and understand the product’s label and Safety Data Sheet (“SDS”) for precautionary and first aid information. The SDS is available on the Nu-Calgon website at www.nucalgon.com